Publicaciones

Seismic hazard in low slip rate crustal faults, estimating the characteristic event and the most hazardous zone: study case San Ramón fault, in southern Andes

Investigadores

Gonzalo Yáñez

Journal

Natural Hazards and Earth System Sciences

Línea de investigación

Amenazas por procesos de tierra sólida

Institución

Pontificia Universidad Católica de Chile

afiliacion

  1. Nicolás P. Estay, nnperez@puc.cl, Pontificia Universidad Católica de Chile, Santiago, Vicuña Mackenna 4686, Chile. CIGIDEN, Santiago, Vicuña Mackenna 4686, Chile. CEGA, Universidad de Chile, Beauchef 850, Santiago, Chile
  2. Gonzalo Yáñez,  Pontificia Universidad Católica de Chile, Santiago, Vicuña Mackenna 4686, Chile. CIGIDEN, Santiago, Vicuña Mackenna 4686, Chile. CEGA, Universidad de Chile, Beauchef 850, Santiago, Chile
  3. Sebastien Carretier, IRD, UR 234, GET, 14 avenue E. Belin, 31400, Toulouse, France. Université de Toulouse, UPS, GET, 14 avenue E. Belin, 314000, Toulouse, France. CNRS, GET, 14 avenue E. Belin, 314000, Toulouse, France. Departamento de Geología, FCFM, Universidad de Chile, Beauchef 850, Santiago, Chile
  4. Elias Lira, Pontificia Universidad Católica de Chile, Santiago, Vicuña Mackenna 4686, Chile
  5. José Maringue, Pontificia Universidad Católica de Chile, Santiago, Vicuña Mackenna 4686, Chile. CIGIDEN, Santiago, Vicuña Mackenna 4686, Chile

Abstract

Crustal faults located close to cities may induce catastrophic damages. When recurrence times are in the range of 1000–10 000 or higher, actions to mitigate the effects of the associated earthquake are hampered by the lack of a full seismic record, and in many cases, also of geological evidences. In order to characterize the fault behavior and its effects, we propose three different already-developed timeintegration methodologies to define the most likely scenarios of rupture, and then to quantify the hazard with an empirical equation of peak ground acceleration (PGA). We consider the following methodologies: (1) stream gradient and (2) sinuosity indexes to estimate fault-related topographic effects, and (3) gravity profiles across the fault to identify the fault scarp in the basement. We chose the San Ramón Fault on which to apply these methodologies. It is a ∼ 30 km N–S trending fault with a low slip rate (0.1–0.5 mm yr−1) and an approximated recurrence of 9000 years. It is located in the foothills of the Andes near the large city of Santiago, the capital of Chile (> 6 000 000 inhabitants). Along the fault trace we define four segments, with a mean length of ∼ 10 km, which probably become active independently. We tested the present-day seismic activity by deploying a local seismological network for 1 year, finding five events that are spatially related to the fault. In addition, fault geometry along the most evident scarp was imaged in terms of its electrical resistivity response by a high resolution TEM (transient electromagnetic) profile. Seismic event distribution and TEM imaging allowed the constraint of the fault dip angle (∼ 65◦) and its capacity to break into the surface. Using the empirical equation of Chiou and Youngs (2014) for crustal faults and considering the characteristic seismic event (thrust high-angle fault, ∼ 10 km, Mw = 6.2–6.7), we estimate the acceleration distribution in Santiago and the hazardous zones. City domains that are under high risk include the hanging wall zone covered by sediments and narrow zones where the fault could break the surface. Over these domains horizontal PGA can be greater than 0.5 g and eventually produce building collapse.

Link

Ver publicación